Dating websites in portland oregon

Posted by / 18-Mar-2020 11:18

The machine is operated much as all pressing machines are..." (National Glass Budget 1910; Lockhart pers. This little bottle has a moderately narrow neck and a distinct valve or ejection mark on the base indicating press-and-blow machine manufacture. The 1908 photo below is from the Lewis Hine collection (Library of Congress) and shows an early, probably O'Neill (Barrett 2011) semi-automatic press-and-blow 4 mold milk bottle (which have relatively wide mouths) machine which came with the following caption: "Machine that blows 4 milk bottles at a time. Blowing air would have been supplied by the hose visible at the top of the set of blow molds to the left, where the final "blow" part of the cycle took place.

Added evidence to this theory is that an identical shape and size (2 oz.) "Round Shoe Polish" bottle is shown in the "Machine Made Ware" section of Cumberland's 1911 catalog (Cumberland Glass 1911). Very few narrow neck bottles made on the Owens machines will pre-date that time also. 2007d].) It is thought that probably all pre-1905 semi-automatic bottle machine production in the U. was relegated to wide-mouth bottles/jars due to limitations of the press-and-blow machines at that time (Toulouse 1967; Miller & Sullivan 1981; Jones & Sullivan 1989; Cable 1999; Miller & Mc Nichol 2002; Lockhart pers. This image (click to enlarge) also shows that on many early press-and-blow machines the parison mold was one-piece (note absence of mold hinges) as the narrow non-inflated parison could be removed from either the base or finish mold end (depending on the type machine) whereas the blow mold had to be two-piece (hinges obvious) to remove the expanded and finished bottle if there was any narrowing from the body to the neck/finish (like a typical milk bottle would have).

On many early (very early 1900s into the 1920s) and occasional later (1930s and later) machine-made bottles the vertical body/neck and finish mold seams are discontinuous and offset from each other; click offset seams for a picture of this attribute.

Both seams are quite diagnostic of machine manufacture and are usually visible, though the seam at the top of the finish can be hard to see on some bottles - especially if the finish was fire polished.

In the glassmaking trade, these seams along with the side mold seams within the finish or just below are referred to as "neck ring" or "neckring" seams since they were formed by the separate neck ring portion of a machine mold (Tooley 1953).

There are at least two additional finish related mold seams - one at the top of the finish which encircles either the bore or sometimes the outside of the upper lip portion of the finish (sometimes of these seams are present) and a horizontal seam immediately below the finish which circles the extreme upper neck (called a "neck ring parting line").

Click on the picture to the left to view an illustration which shows both of these seams or click machine-made finish to view an image which shows well the seam below the finish.

dating websites in portland oregon-61dating websites in portland oregon-56dating websites in portland oregon-37

: There are a few machine-made bottle types (milk, shoe polish and small ink bottles) or post-production processes (fire polishing) which exhibit mold seams in the finish/upper neck that deviate from the descriptions in points #1 and/or #3 above; these bottles may appear to be of mouth-blown manufacture.

One thought on “dating websites in portland oregon”